Hyundai Tucson: Driveshaft and axle
- Specifications
- Special Service Tools
- Front Axle Assembly. Front Hub / Knuckle / Tone Wheel
- Driveshaft Assembly
- Rear Axle Assembly. Rear Hub - Carrier
- Rear Driveshaft Assembly. Rear Driveshaft
- Propeller Shaft Assembly. Propeller Shaft
- Differential Carrier Assembly. Rear Differential Carrier
4WD Control System
- Adjustment
Description
The friction material inside the coupling will degrade over time.
Therefore, corresponding compensation values must be referenced and
entered after replacing the cont ...
Specifications
- Specification
ItemsInner sideOuter side
Front driveshaftJoint type CWTJ#24 BJ#24
Max. permissible angle26°46.5°
Rear driveshaftJoint typeLTJ#20LBJ#20
Max. permissible angle20°
Rear differ ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Oil Pressure Control Solenoid Valve
- Removal and Installation
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(Refer to General Information - "Lift and
Support Points")
1.Disconnect the batt ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Electric EGR Control Valve
- Description
The Electric EGR Control Valve is installed in between the EGR cooler
and the exhaust line and is a solenoid valve. This valve controls EGR
(Exhaust Gas Recirculation) amount by the ECM's duty control signal
depending on engine load and the need of intake air.The Exhaust Gas
...
