1.Remove the front drive shaft.(Refer to Driveshaft Assembly - "Front Driveshaft")
2.Remove the trans axle side joint.(Refer to Driveshaft Assembly - "Transaxle Joint")
3.Remove the dynamic damper band (A, B) using driver (-).


• When removing the dynamic damper, lubricate the shaft with soapy water to prevent shaft damage.
4.Remove the dynamic damper (A).

1.Install the dynamic damper (A).

• When installing the dynamic damper, install it in set with the mounting part (A) of the shaft.
2.Install the dynamic damper band (A) using SST (09495-39100).

3.Install the transaxle side joint.(Refer to Driveshaft Assembly - "Transaxle Joint")
4.Install the front driveshaft.(Refer to Driveshaft Assembly - "Front Driveshaft")
Front Driveshaft
Joint Assembly (Transaxle side)Hyundai Tucson (NX4) 2022-2026 Owner's Manual: SRS Components
The SRS consists of the following
components:
1 Driver's front airbag module
2 Passenger's front airbag module
3 Side airbag modules
4 Curtain airbag modules
5 Retractor pretensioner
6 Airbag warning light
7 SRS control module (SRSCM)/Rollover
sensor
8 Front impact sensors
9 S ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Jump Starting
Jump starting can be dangerous if done
incorrectly. Follow the jump starting
procedure in this section to avoid serious
injury or damage to your vehicle. If in
doubt about how to properly jump start
your vehicle, have a service technician or
towing service do it for you.
WARNING
To pre ...