Hyundai Tucson: Automatic Climate Control System / Manual Heating and Air Conditioning
1. Start the engine.
2. Set the mode to the desired position. For improving the effectiveness of heating and cooling, select:
- Heating:.png)
- Cooling:.png)
3. Set the temperature control to the desired position.
4. Set the air intake control to the outside (fresh) air position.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn on the air conditioning system.
7. Press the AUTO button to convert to full automatic control of the system.
Automatic Heating and Air
Conditioning
The Automatic Climate Control System
is controlled by setting the desired
temperature.
1. Press the AUTO button. The
modes, fan speeds, air intake, and
air conditioning are controlled
autom ...
Mode selection
The mode selection button controls the direction of the air flow through the
ventilation
system.
The air flow outlet direction is cycled as
follows:
Face-Level (B, C, E)
Air flow is d ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Heater Core
- Replacement
1.Disconnect the negative (-) battery terminal.
2.Remove the heater and blower assembly.(Refer to Heater - "Heater Unit")
3.Loosen the mounting screws and remove the heater core cover (A).
4.Separate the heater core (A) from the heater unit.
5.Install in the reverse ord ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Accelerator Position Sensor (APS)
- Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS
is one of the most important sensors in engine control system, so it
consists of the two sensors which adapt individual sensor power ...
