Hyundai Tucson: Manual Heating and Air Conditioning / Mode selection
The mode selection button controls the direction of the air flow through the ventilation system.
The air flow outlet direction is cycled as follows:
Face-Level (B, C, E)
Air flow is directed toward the upper body and face. Additionally, each outlet can be controlled to direct the air discharged from the outlet.
Bi-Level (B, C, D, E, F)
Air flow is directed toward the face and the floor.
Floor-Level (A, B, D, E, F)
Most of the air flow is directed to the floor, with a small amount of the air being directed to the windshield and side window defrosters.
Floor/Defrost-Level (A, B, D, E, F)
Most of the air flow is directed to the floor and the windshield with a small amount directed to the side window defrosters.
Defrost-Level (A, B)
Most of the air flow is directed to the windshield with a small amount of air directed to the side window defrosters.
Multi air mode (B, C, D, E, F, G)
.png)
Gentle breezes come out from the outlet vents.
Instrument panel vents
.png)
Front
.png)
Rear
The instrument panel vent air flow can be directed up/down or left/right using the vent adjustment lever. The air flow can also be CLOSED using the vent adjustment lever.
Manual Heating and Air
Conditioning
1. Start the engine.
2. Set the mode to the desired position.
For improving the effectiveness of
heating and cooling, select:
- Heating:
- Cooling:
3. Set the temperature control to the
des ...
Temperature control
Type A
Type B
The temperature setting increases when
you toggle up or press the UP arrow on
the touchscreen (if equipped).
The temperature setting decreases when
you toggle down or press ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Door Belt Outside Weatherstrip
- Replacement
1.Pull down the rear door window glass to the lowest level by pressing the power window glass switch.
2.Remove the rear door belt outside weatherstrip (A).
3.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Fuel Pump
- Inspection
[Fuel Pump]
1.Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.Remove the fuel pump assembly.
3.Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5)
Pin NoDiscription
1Fuel sender signal
2-
3Fuel sender ground
...
