Hyundai Tucson: Interior Trim / Front Pillar Trim
1. Front pillar trim
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the front pillar trim.
(1)To remove the front pillar trim, the fastener remover (A) below must be used.
(2)After slightly lifting up the front pillar trim and putting the tool in, remove the mounting clip (A) by pulling it.
• Once the front pillar trim is removed, be sure to replace the clips with new ones.
(3)Remove the front pillar trim (A).
2.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
Cowl Side Trim
- Component Location
1. Cwol side trim
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage ...
Center Pillar Trim
- Component Location
1. Center pillar lower trim2.Center pillar upper trim
- Replacement
[Center pillar lower trim]
• When removing with a flat-tip screwdriver or ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Occupant Alert
Description and Operation
- Description
The system detects the passenger in the vehicle and prevents the driver
from getting off the vehicle with the passenger in the back.
– 1st warning: If you open the driver's door after you open and then
close the rear passenger and turn the engine ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Intake Actuator
- Description
The intake actuator is located at the blower unit. It regulates the
intake door by a signal from the control unit. Pressing the intake
selection switch will shift between recirculation and fresh air modes.
- Components
1. Intake actuator
- Inspection
1.Turn the i ...
