Hyundai Tucson: Interior Trim / Cowl Side Trim
1. Cwol side trim
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the front door scuff trim.(Refer to Interior Trim - "Door Scuff Trim")
2.Remove the hood latch release handle.(Refer to Hood - "Hood Latch Release Handle")
3.Remove the front door body side weatherstrip.(Refer to Front Door - "Front Door Side Weatherstrip")
4.Using a screwdriver or remover, remove the cowl side trim (A).
5.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
Door Step Trim
- Component Location
1. Front door step trim2. Rear door step trim
- Replacement
• When prying with a flat-tip screwdriver, wrap it with protective
tape, and appl ...
Front Pillar Trim
- Component Location
1. Front pillar trim
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent dam ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Locking/Unlocking the doors
A : Door handle authentication pad,
B : NFC Antenna
To unlock:
Place the digital key (card key) near the
door handle authentication pad of the
driver or passenger side door for about 2
seconds.
If you unlock your vehicle from the
passenger side door handle, all the
doors are unlocke ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Camshaft Position Sensor (CMPS)
- Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects the
camshaft position by using a hall element.It is related with Crankshaft
Position Sensor (CKPS) and detects the piston position of each cylinder
which the CKPS can't detect.The CMPS is installed on engine head cov ...
