Hyundai Tucson: Heating and Air Conditioning / Fan speed control & Air conditioning (A/C)
Fan speed control
.png)
Turn the knob to the right to increase the fan speed and airflow. Turn the knob to the left to decrease fan speed and airflow.
Setting the fan speed control knob to the “0” position turns off the fan.
Information
Operating the fan speed when the ignition switch is in the ON position may cause the battery to discharge.
Air conditioning (A/C)
.png)
Press the A/C button to turn on the air conditioning system (indicator light ON). Press the button again to turn off the air conditioning system.
Temperature & Air intake control
Temperature control
The temperature increases by turning
the knob to the right. The temperature
decreases by turning the knob to the left.
Air intake control
To select outside (fresh) air or ...
System Operation
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the
outside (fresh) air position.
3. Set the temperature control to the
desired position.
4. Set the fan speed co ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Inspection
Front Door Lock Module Inspection
1.Remove the front door trim.(Refer to Body - "Front Door Trim")
2.Disconnect the connectors from the actuator.
3.Check actuator operation by connecting power and ground according to the table.PinDescription
DriverPanssenger
1-M2
2-M3
3COM- ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Upper Arm
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
Points")
1.Loosen the rear wheel nuts slightly.Raise the v ...
