Hyundai Tucson (NX4) 2022-2026 Owner's Manual / Driver Assistance System / Blind-Spot Collision Warning (BCW)

Hyundai Tucson: Driver Assistance System / Blind-Spot Collision Warning (BCW)

Blind-Spot Collision Warning uses the rear corner radar to help detect approaching vehicles in the driver’s blind spot areas and warn you of a possible collision with a warning message and audible warning.

Blind-Spot Collision Warning helps detect and warns you that a vehicle is in the blind spot area.

WARNING

The detection range may differ depending on the speed of your vehicle. Vehicles in the blind spot area may not be detected by Blind-Spot Collision Warning when you pass other vehicles at high speeds.

Blind-Spot Collision Warning helps detect and warns you that a vehicle is approaching at high speed from the blind spot area.

The warning timing may differ depending on the speed of the vehicle approaching you at high speed.

Information

Refer to the "Driver Assistance Sensors" section in this chapter for the location and the general precautions of rear corner radar.

Lane Keeping Assist Malfunction and Limitations

Lane Keeping Assist malfunction When Lane Keeping Assist is not working properly, the "Check Lane Keeping Assist (LKA) system" message may appear and the yellow indicator light may illumi ...

Blind-Spot Collision Warning Settings

Blind-Spot Safety With the ignition switch ON, go to User Settings > Driver Assistance > Blind- Spot Safety (for cluster type) or Setup > Vehicle > Driver Assistance > Blind-Sp ...

Other information:

Hyundai Tucson (NX4) 2022-2026 Service Manual: Towing. General Information
General Information - Towing If the vehicle needs to be towed, call a professional towing service. Never tow vehicle with just a rope or chain. It is very dangerous.[Front] [Rear] Emergency Towing There are three popular methods of towing a vehicle : – The operator loads the vehicle o ...

Hyundai Tucson (NX4) 2022-2026 Service Manual: Timing Chain
- Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.(Refer to General Information - "Lift and Support Points") 1.Set No.1 cylinder to TDC. Turn the c ...