Hyundai Tucson: Blind-Spot Collision Warning (BCW) / Blind-Spot Collision-Avoidance
Assist Operation
Collision warning
.png)
When a vehicle is detected in a blind
spot, the warning light on the side view
mirror illuminates.
- Blind-Spot Collision Avoidance Assist
operates when your vehicle speed
is above 12 mph (20 km/h) and the
speed of the vehicle in the blind spot
area is above 7 mph (10 km/h).
Collision warning may operate when the
turn signal is turned on in the direction of
a detected vehicle.
- To warn you of a potential collision,
the warning light on the side view
mirror may blink and an audible
warning may sound.
- When the turn signal is turned off or
you move away from the vehicle in
the blind spot, the function returns to
vehicle detection state.
WARNING
- The detection range of the rear corner
radar is determined by a standard
road width. On narrow roads, the
function may detect other vehicles in
the next lane and warn you. On wide
roads, the function may not be able
to detect a vehicle driving in the next
lane and may not warn you.
- When the hazard warning flasher is
on, the collision warning initiated by
activating the turn signal may not
operate.
Blind-Spot Safety
With the ignition switch ON, go to User
Settings > Driver Assistance > Blind-
Spot Safety (for cluster type) or Setup >
Vehicle > Driver Assistance > Blind-Sp ...
To warn you of a potential collision, the
warning light on the side view mirror may
blink, a warning message may appear on
the instrument cluster, and an audible
warning may sound.
Blind ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Fuel Pump Motor
- Removal
1.Remove the fuel pump.(Refer to Fuel Delivery System - "Fuel Pump")
2.Disconnect the fuel sender connector (A).
3.Release the fixing hook (A) and then remove fuel sender (B) in the arrow direction.
4.Disconnect the fuel pump motor connector (A).
5.Remove the fixing pin (A) ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Door Side Weatherstrip
- Replacement
[Rear door side weatherstrip]
1.Loosen the rear door checker (B) mounting bolt.Tightening torque :16.7 - 21.6 N.m (1.7 - 2.2 kgf.m, 12.3 - 15.9 lb-ft)
2.Detach the clips, then remove the rear door side weatherstrip (A).
3.To install, reverse removal procedure.
[Rear door bod ...