Blind-Spot Collision-Avoidance Assist uses the front view camera and the rear corner radar to help detect approaching vehicles in the driver’s blind spot areas and warn you of a possible collision with a warning message and audible warning.
If there is a collision risk when changing lanes or driving forward out of a parking space, Blind-Spot Collision-Avoidance Assist may brake your vehicle to help avoid a collision.
.png)
Blind-Spot Collision-Avoidance Assist helps detect and warns you that a vehicle is in the blind spot area.
WARNING
The detecting range may differ depending on the speed of your vehicle. Vehicles in the blind spot area may not be detected by Blind-Spot Collision- Avoidance Assist when you pass other vehicles at high speeds.
.png)
Blind-Spot Collision-Avoidance Assist helps detect and warns you that a vehicle is approaching at high speed from the blind spot area.
The warning timing may differ depending on the speed of the vehicle approaching you at high speed.
.png)
Blind-Spot Collision-Avoidance Assist may brake your vehicle if there is a detected collision risk when changing lanes.
.png)
Blind-Spot Collision-Avoidance Assist may brake your vehicle if there is a detected collision risk when driving forward out of a parking space.
Information
Refer to the "Driver Assistance Sensors" section in this chapter for the location and the general precautions of front view camera and rear corner radar.
Blind-Spot Collision Warning
Malfunction and Limitations
Blind-Spot Collision-Avoidance
Assist SettingsHyundai Tucson (NX4) 2022-2026 Service Manual: Front Door Inside Handle
- Replacement
1.Disconnect the negative ( - ) battery terminal.
2.Remove the front door trim.(Refer to Front Door - "Front Door Trim")
3.Loosen the mounting screws and remove the front door inside handle (A).
4.To install, reverse removal procedure.
• Make sure the doo ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Glove Box
- Component Location
1. Glove box
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to ...