Hyundai Tucson: Body Side Molding / Side Sill Molding
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Loosen the mounting screws, remove the side seal molding (A).
2.To install, reverse the removal procedure.
• Replace any damaged clips (or pin-type retainers).
Roof Side Molding
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Tail Gate Garnish
- Component Location
1. Liftgate back panel
- Replacement
• Put on gloves to prevent hand injuries.
• Take care not to scratch the liftgate ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Inspection
Tolerance Calibration Outline
• SVM calibration tool is required to perform tolerance calibration as shown below.
• Refer to the information below to purchase the SVM calibration tool.
– Tool Name : GDS SVM HYUNDAI (SVM-100)
– Representative purc ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Seat Belts
Seat Belt Safety Precautions
Always fasten your seat belt and make
sure all passengers have fastened their
seat belts before starting any trip.
Airbags are designed to supplement the
seat belt as an additional safety device,
not a replacement. Most states require all
vehicle occupants w ...
