Hyundai Tucson: Body Side Molding / Roof Side Molding
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Using a screwdriver or remover, remove the roof side molding (A).
2.To install, reverse the removal procedure.
• Replace any damaged clips (or pin-type retainers).
Rear Wheel Guard
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Side Sill Molding
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Description and Operation
- Description
Idle Stop & Go (ISG) system switches off the ignition when vehicle
is stopped, and then restarts the ignition and starts the vehicle when
accelerator is pushed. It temporarily stops the engine while waiting for
signal or idling to improve fuel efficiency and reduce exhaust ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Description and Operation
- Description
Emissions Control System consists of three major systems. • The
Crankcase Emission Control System prevents blow-by gas from releasing
into the atmosphere. This system recycles gas back into the intake
manifold (Closed Crankcase Ventilation Type).
• The Evaporative Emiss ...
