Hyundai Tucson: Body Side Molding / Tail Gate Garnish
1. Liftgate back panel
• Put on gloves to prevent hand injuries.
• Take care not to scratch the liftgate and body surface.
1.Remove the liftgate lower trim.(Refer to Liftgate - "Liftgate Trim")
2.Using a screwdriver or remover, remove the liftgate back panel (A).
3.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
Side Sill Molding
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Sunroof
...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Knock Sensor (KS)
- Description
Knocking is a phenomenon characterized by undesirable vibration and
noise and can cause engine damage. Knock Sensor (KS) is installed on the
cylinder block and senses engine knocking.When knocking occurs, the
vibration from the cylinder block is applied as pressure to the
pi ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Remote Smart Parking Assist Operation
Remote Smart Parking Assist button
Remote Operation
Operating order
1. Getting ready to remotely move forward
and backward
There are two ways to operate the
Remote Operation function.
Method 1: Using the function with
engine off.
(1) Within a certain range from your
vehicle press t ...
