Hyundai Tucson: Airbag Module / Side Airbag (SAB) Module
• Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.
1. Side airbag (SAB)
1.Disconnect the battery negative terminal.
• After disconnecting the cables, wait at least 3 minutes.
2.Remove the front seat back cover.(Refer to Body - "Front Seat Back Cover")
3.Remove the side airbag (A) by loosening the nuts.
Tightening torque :5.9 - 7.8 N.m (0.6 - 0.8 kgf.m, 4.3 - 5.8 lb-ft)
1.Install in the reverse order of removal.
2.After installing the airbag module, confirm proper system operation.
• Switch ON the ignition. The SRS indicator light should turn on for about three-six seconds and then off.
Passenger Airbag (PAB) Module
- Description
The passenger airbag (PAB) is installed inside the crash pad and
protects the front passenger in the event of a frontal crash. The SRSCM
determines if and when to deploy the PAB.
...
Curtain Airbag (CAB) Module
- Description
Curtain airbags are installed inside the headliner (LH and RH) and
protect the the heads of the front seat occupants and the rear outboard
seat occupants from danger when side cra ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Description and Operation
- Description and Operation
Blcok Diagram
• This system monitors the driving situations through the radar
and the camera. Thus, for a situation out of the sensing range, the
system may not normally operate.
The System may be limited when :
• The radar sensor or ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Safe Exit Warning(Sew)
Safe Exit Warning uses the rear
corner radars to help detect a vehicle
approaching the rear of your vehicle,
after the vehicle is stopped and a
passenger opens a door.
If Safe Exit Warning is activated, an
audible warning sounds and a warning
message may appear on the instrument
clu ...
