• Never attempt to measure the circuit resistance of the airbag module even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

1. Curtain Air Bag (CAB)
1. isconnect the battery negative terminal.
• After disconnecting the cables, wait at least 3 minutes.
2.Remove the roof trim.(Refer to Body - "Roof Trim Assembly")
3.Disconnect the connector (A) from the curtain Airbag module.

4.Remove the curtain airbag module (A) after loosening the bolt and nut.
Tightening torque :Bolt : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)Nut : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.4 lb-ft)

1.Install in the reverse order of removal.
2.After installing the airbag module, confirm proper system operation.
• Switch ON the ignition. The SRS indicator light should turn on for about three-six seconds and then off.
Side Airbag (SAB) Module
Center Side Air Bag Module(CSAB)Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Forward Collision-Avoidance
Assist Settings
Forward Safety
With the ignition switch ON, go to User
Settings > Driver Assistance > Forward
Safety (for cluster type) or Setup >
Vehicle > Driver Assistance > Forward
Safety (for infotainment system type)
from the Settings menu to select the
following:
If Active A ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Schematic Diagrams
- System Block Diagram
Component Parts And Function Outline
Component partFunction
Vehicle-speed sensor, ESP/ABS Control ModuleConverts vehicle speed to pulse.
ECMReceives signals from sensor and control switches.
Cruise control indicatorIlluminate when CRUISE main switch is ON (Built into ...