Scheduled Ventilation Control (if equipped)
The Scheduled Ventilation Control releases hot air in the vehicle to lower the cabin temperature before getting in the vehicle.
Depending on the outside ambient temperature, the blower is operated for 5 to 15 minutes while the vehicle is parked. This feature must be enabled from the Settings menu in the infotainment system.
Select: Setup > Vehicle > Automatic Ventilation > Scheduled Ventilation Control
The starting time can be set within 24 hours. Schedule Ventilation Control operates only once when the feature is set.
Automatic Controls for the Driver Based on Climate Control System Settings
The temperature of the driver’s seat warmer, the air ventilated seat, and steering wheel heater are automatically controlled depending on the inside and outside temperature of the vehicle when the engine is running.
These features must be enabled from the Settings menu in the infotainment system.
Select: Setup > Vehicle > Seat (or Climate) > Warmer/Ventilation Features > Link to Climate Settings for Auto-Adjustment
For more information on Auto Comfort Control, refer to the “Seat Warmers” and “Air ventilation seats” sections in Chapter 3 and the “Steering Wheel Heater” section in Chapter 5.
Information
The infotainment system may change after software updates. For more information, refer to the user’s manual provided in the infotainment system and the quick reference guide.
Sunroof Inside Air Recirculation. Auto Dehumidify
Storage CompartmentHyundai Tucson (NX4) 2022-2026 Service Manual: Fender
Components and Components Location
- Component Location
1. Fender assembly
Repair procedures
- Replacement
• When removing the fender, wrap protective tape around a screwdriver or remover not to damage components
• Put on gloves to prevent hand injuries
1. ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: PTG Spindle
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the rear pillar trim.(Refer to Body (Interior and Exterior) - Interior Trim - Rear Pillar Trim)
3.Disconnect the PTG spindle connector (A).
4.Using a flat-tip screwdriver, remove the mounting clip (A).
5.Remove the spind ...