Hyundai Tucson: Body Side Molding / Rear Spoiler
1. Rear Spoiler
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Remove the liftgate upper trim.(Refer to Liftgate - "Liftgate Trim")
2.Disconnect the rear stop lamp connector (A).
3.Remove the liftgate plug hole (A).
4.Loosen the mounting nuts, remove the rear spoiler (A).
Tightening torque : 3.3 - 4.4 N.m (0.34 - 0.46 kgf.m, 2.5 - 3.3 lb-ft)
5.To install, reverse the removal procedure.
• Make sure the connector is connected properly.
• Replace any damaged clips (or pin-type retainers).
Roof Rack
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Fender Garnish
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Operating the Power Liftgate
Power liftgate open/close button
(Smart key, Instrument panel)
When the liftgate is closed, press the
power liftgate open/close button for 1
second. The power liftgate opens with a
warning sound.
While the liftgate is opening, press the
button to stop liftgate operation.
When the po ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Forward Collision–Avoidance Assist (FCA) (Sensor fusion)
Basic function
Forward Collision-Avoidance Assist uses
the front view camera and front radar to
help detect a vehicle, a pedestrian, or a
cyclist ahead on the road. The function
may warn you with a warning message
on the instrument cluster and an audible
warning if a collision is immi ...
