Hyundai Tucson (NX4) 2022-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Fender Garnish

Hyundai Tucson: Body Side Molding / Fender Garnish

- Replacement

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• Put on gloves to prevent hand injuries.

1.Using a screwdriver or remover, remove the fender garnish (A).

2.To install, reverse removal procedure.

• Replace any damaged clips (or pin-type retainers).

Rear Spoiler

- Component Location 1. Rear Spoiler - Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage t ...

Quarter Garnish

- Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Put on gloves to prevent h ...

Other information:

Hyundai Tucson (NX4) 2022-2026 Service Manual: Immobilizer Control Unit
- Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the heater control unit.(Refer to Heating,Ventilation And Air Conditioning - "Heater Control Unit") 3.Loosen the mounting bolt,nut,screw and remove the Integrated Body Control Unit (A). 4.Disconnect the connectors and remov ...

Hyundai Tucson (NX4) 2022-2026 Service Manual: Description and Operation
- Description • The hydraulic system consists of a valve body, an oil filter and an oil pump. • The oil pump is powered by the engine. ATF passes through the oil filter and gets distributed along the oil channels. • The oil becomes highly pressurized as it exits the oil pump and pa ...