Hyundai Tucson: Cooling System / Reservoir Tank
1.Remove the reservoir tank.
(1)Disconnect the water hose (A).
(2)Disconnect the degassing hose (B).
(3)Remove the reservoir tank (C).
Tightening torque :7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.6 Ib-ft)
2.Install in the reverse order of removal.
Cooling Fan
- Removal and Installation
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle ...
Integrated Thermal Management Module (ITM)
- Components
1. Integrated Thermal management Module (ITM)
1. Water inlet pipe2. O-ring
- Description
The Integrated Thermal management Module (ITM) is a device that
controls the c ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Ignition Coil
- Description
The ignition coil is mounted on the top side of the cylinder head cover
end. The ignition coil consists of the primary coil that receives
battery power and the secondary coil that generates high voltage.When
the current in the primary coil is cut off by the ignition signal of ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Components and Components Location
- Engine Room
1. Compressor2. Service port (Low pressure)3. A/C pressure transducer (APT)4. Service port (High pressure)5. Suction & Liquid pipe assembly6. Expansion valve cover
- Interior
1. Auto defogging sensor2. Photo sensor3. PM sensor4. Heater & A/C control unit5. Heater ...
