1. Radiator grill
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the bumper cover and panels.
1.Remove the front bumper assembly.(Refer to Front Bumper - "Front Bumper Assembly")
2.Detach the wiring (A) mounted on the front bumper assembly and radiator grill.
3.Remove the front bumper energy absorber (A).
4.Loosen the mounting screws, remove the radiator grill cover assembly (A).
5.Loosen the monting screws, remove the radiator grill upper cover (A).
6.To install, reverse removal procedure.
• Make sure the connector is connected properly.
• Replace any damage clips.
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Reverse Parking Collision-
Avoidance Assist Settings
With the ignition switch ON, go to User
Settings > Driver Assistance > Parking
Safety (for cluster type) or Setup >
Vehicle > Driver Assistance > Parking
Safety (for infotainment system type)
from the Settings menu to select the
following:
If Rear Active Assist is se ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Joint Assembly (Transaxle side)
- Removal
• Drive shaft joints require special grease, so do not add any other type of grease.
• When replacing the boot band, it must be a new one.
1.Remove the front drive shaft.(Refer to Driveshaft Assembly - "Front Driveshaft")
2.Remove the transaxle side large ...