Hyundai Tucson: Front Bumper / Front Bumper Assembly

- Component Location

1. Front bumper assembly

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• Put on gloves to prevent hand injuries.

• Take care not to bend or scratch the bumper cover and panels.

1.Disconnect the negative (-) battery terminal.

2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")

3.Remove the fender garnish (A).

4.Loosen the front bumper upper mounting clips.

5.Loosen the mounting clis and screws on the side of front bumper (A), detach the side part of front bumper.

• When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

6.Disconnect the front bumper main connector (A).

7.Remove the front bumper assembly (A).

8.To install, reverse removal procedure.

• Make sure the connector is plugged in properly.

• Replace any damaged clips (or pin-type retainers).