

1.With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.


2.With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch.



1.Disconnect the negative (-) battery terminal.
2.Remove the front seat shield outer cover.(Refer to Body - "Front Seat Shield Outer Cover")
3.Remove the power seat control switch (A) after loosening screws.

1.Install the power seat control switch after connecting the connector.
2.Install the front seat shield outer cover.
3.Connect the negative (+) battery terminal.
Power Seat Motor
Seat Heater (Non-Air Ventilation)Hyundai Tucson (NX4) 2022-2026 Service Manual: Joint Assembly (Wheel side)
- Removal
The type can replace the wheel side joint boot
1.Remove the front drive shaft.(Refer to Driveshaft Assembly - "Front Driveshaft")
2.Remove the trans axle side joint.(Refer to Driveshaft Assembly - "Transaxle Joint")
3.Remove the dynamic damper.(Refer to Driveshaft Assembly - "Dynam ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Special Service Tools
- Special Service Tools
Tool (Number and Name)IllustrationUse
Deployment tool0957A-34100A
Airbag deployment tool.Use with (0957A-AL140, 0957A-AL160)
Dummy0957A-38200
Simulator to check the resistanceof each wiring harness.Use with (0957A-AL170, 0957A-AL190)
Airbag deployment & dummy adapte ...