1.Remove the front seat assembly.(Refer to Body - "Front Seat Assembly")A: Slide motorB: Rear height motorC: Front height motorD: Lumbar support motor E: Reclining motor





2.When the battery power is supplied to the motor connector, check the motor for smooth operation.
3.Reverse the connections and check that the motor turns in reverse.
4.If there is an abnormality, replace the motors.


1.Disconnect the limit switch and operate the limit switch and then check for continuity between the terminals.
2.Make sure that the seat operation is normal in the reverse after the maximum operation.
3.If there is an abnormality, replace the limit switch.


Components and Components Location
Power Seat Control SwitchHyundai Tucson (NX4) 2022-2026 Service Manual: Rear Driveshaft Assembly. Rear Driveshaft
Rear Driveshaft
- Components
1. Rear drive shaft
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Front Monitor
- Removal
1.Disconnct the negative (-) battery terminal.
2.Remove the front monitor lower cover (A).
3.Remove the front monitor lower cover after disconnecting the mood lamp connector (A).
4.Remove front monitor side cover (A) and (B).
5.Remove the front monitor assembly (A).
6.R ...