Hyundai Tucson: Warning and Indicator Lights / High beam indicator light. High Beam Assist indicator light. Cruise indicator light
High beam indicator light
This indicator light illuminates:
- When the headlights are on and turn signal lever is moved to high beam position.
- When the turn signal lever is pulled into the Flash-to-Pass position.
High Beam Assist indicator light
This indicator light illuminates:
When the high-beam is on with the light switch in the AUTO position.
- White: When High Beam Assist is ready to operate.
- Green: When High Beam Assist is operating.
If your vehicle detects oncoming vehicles in front of you, High Beam Assist switches the high beam to low beam automatically.
For more information, refer to the “High Beam Assist (HBA)” section in Chapter 5.
Cruise indicator light
This indicator light illuminates:
When the Cruise Control system is enabled.
For more information, refer to the "Cruise Control (CC)" section in chapter 7.
AUTO STOP indicator light. Turn signal indicator light
AUTO STOP indicator light
This indicator light illuminates:
When the engine enters the Idle Stop
mode of ISG (Idle Stop and Go) system.
When the engine automatically starts,
the AUTO STOP ind ...
SPORT mode indicator light. SMART mode indicator light. SNOW mode indicator
light
SPORT mode indicator light
This indicator light illuminates
When you select "SPORT" mode as the
drive mode.
For more information, refer to the "Drive
Mode Integrated Control System" section
...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Tongue load
The tongue load is extremely important
when setting up your trailer for towing
with your vehicle. Excessive tongue load
reduces front tire traction and steering
control. For example, too little tongue
load can make the trailer unstable,
causing the trailer to sway because the
weight ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Condenser
- Components Location
1. Condensor
- Inspection
1.Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent,
gently bend them using a screwdriver or pliers.
2.Check the condenser connections for leakage, and rep ...
