Hyundai Tucson: Front Seat Belt / Height Adjust
1. Height adjust
1.Remove the front seat belt upper anchor.(Refer to Front Seat Belt - "Front Seat Belt Pretensioner")
2.After loosening the mounting bolts, then remove the height adjust (A).
Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)
3.To install, reverse removal procedure.
• Replace any damaged clips (or pin-type retainers).
Front Seat Belt Pretensioner
- Component Location
1. Front seat belt pretensioner
- Replacement
• When installing the belt, make sure not to damage the pretensioner.
1.Disconnect the negativ ...
Front Seat Belt Buckle
- Component Location
1. Front seat belt buckle
- Replacement
1.Remove the front seat assembly.(Refer to Front Seat - "Front Seat Assembly")
2.After loosening the mounting bolt, then r ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Repair procedures
- Compression Pressure Inspection
• If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.Start the engine until coolant temperature goes up to 80-95°C and stop the engine.
2.Remove the spark coils.(Refer to E ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Filler-Neck Assembly
- Removal
• Be careful not to damage the parts located under the vehicle
(floor under cover, canister, fuel tank) when raising the vehicle using
the lift.(Refer to General Information - "Lift and Support Points")
1.Turn the ignition switch OFF and disconnect the batter ...
