
1. Front seat belt pretensioner
• When installing the belt, make sure not to damage the pretensioner.
1.Disconnect the negative (-) battery terminal.
2.Remove the center pillar upper trim.(Refer to Interior Trim - "Center Pillar Trim")
3.Loosen the mounting bolt and remove the front seat belt upper anchor (A).
Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

4.Press the lock pin and separate the front seat belt pretensioner connector (A).

5.Loosen the mounting bolt and remove the front seat belt pretensioner (A).
Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

6.To install, reverse removal procedure.
• When installing the connector, be sure to insert it to the anchor pretensioner until "click" sound is heard and then check it for secure installation by pulling it.
• After installing the front seat belt retractor, check that the air bag warning indicator illuminates for about 6 seconds when the ignition is ON and then goes out.
• Make sure the connector is plugged in properly.
• Replace any damaged clips (or pin-type retainers).
Components and Components Location
Height AdjustHyundai Tucson (NX4) 2022-2025 Owner's Manual: Automatic Transmission
A: Shift lever, B: Shift release button,
C: Manual shift mode
Depress the brake pedal and
press the
Shift release button while moving the
shift lever.
Press the Shift release button
while
moving the shift lever.
The shift lever can freely
operate.
Button type
Depress the br ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Outside Rear View Mirror
- Component Location
1. Outside rear view mirror
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Remove the front door ...