Hyundai Tucson (NX4) 2022-2026 Owner's Manual / Driver Assistance System / Forward Collision–Avoidance Assist (FCA) (Sensor fusion)

Hyundai Tucson: Driver Assistance System / Forward Collision–Avoidance Assist (FCA) (Sensor fusion)

Basic function

Forward Collision-Avoidance Assist uses the front view camera and front radar to help detect a vehicle, a pedestrian, or a cyclist ahead on the road. The function may warn you with a warning message on the instrument cluster and an audible warning if a collision is imminent. If necessary, it may assist with braking your vehicle to help reduce collision speed and avoid a collision.

Junction Turning function

This function uses the front view camera and front radar to help detect oncoming vehicles in an adjacent lane when turning left at an intersection with the turn signal on. If there is a collision risk, it may assist with braking your vehicle to help avoid a collision.

Information

Refer to the "Driver Assistance Sensors" sections in this chapter for the location and the general precautions of front view camera and front radar.

Limitations of Forward Collision- Avoidance Assist

Forward Collision-Avoidance Assist may not operate normally or may operate unexpectedly if: The front view camera is blocked, covered, or damaged by snow, water, or dirt. The temperatu ...

Forward Collision-Avoidance Assist Settings

Forward Safety With the ignition switch ON, go to User Settings > Driver Assistance > Forward Safety (for cluster type) or Setup > Vehicle > Driver Assistance > Forward Safet ...

Other information:

Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Smart Cruise Control Operation
Operating conditions Basic function Smart Cruise Control operates when the following conditions are met: The gear is in D (Drive). Your vehicle speed is within the operating speed range. - 5-110 mph (10-180 km/h): When there is no vehicle in front - 0-110 mph (0-180 km/h): When ...

Hyundai Tucson (NX4) 2022-2026 Service Manual: Ambient Sensor
- Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.The sensor output will be used for discharge t ...