Hyundai Tucson: Fuel Delivery System / Filler-Neck Assembly
• Be careful not to damage the parts located under the vehicle (floor under cover, canister, fuel tank) when raising the vehicle using the lift.(Refer to General Information - "Lift and Support Points")
1.Turn the ignition switch OFF and disconnect the battery (-) terminal.
2.Lift the vehicle.
3.Open the fuel filler cap (A) by turning it in the counterclockwise.
4.Remove the LH rear wheel guard.(Refer to Body (Interior and Exterior) - "Rear Wheel Guard")
5.Separate the fuel filler hose (A).
6.Separate the fuel ventilation hose (B) and then remove the fixing clip (C).
7.Remove the filler-neck assembly (A) after loosening the mounting nut (B).
Tightening Torque :7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)
1.Install in the reverse order of removal.
Fuel Line
- Removal
Low Pressure Fuel Line [Low Pressure Delivery Pipe ↔ Fuel Tank]
• Be careful not to damage the parts located under the vehicle
(floor under cover, canister, fue ...
Accelerator Pedal
- Removal
1.Turn the ignition switch OFF and disconnect the battery (-) terminal.
2.Disconnect the accelerator position snesor connector (A).
3.Remove the upper mounting cap (B) and the loosen ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Description and Operation
- Warning Lamp Activation
Warning Lamp Behavior after Ignition On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a LED lamp check.The lamp
shall turn on for 6 seconds during the initialization phase and be
turned off afterw ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Components and Components Location
- Component Location
1. Head lamp (Low & High)2. Head lamp (Low)3. Head lamp (High)4. Turn signal lamp5. Daytime running light (DRL) & Positioning lamp6. Side repeater lamp7. Overhead console lamp8. Vanity lamp9. Rear personal lamp10. Luggage lamp11. Head lamp (Static Bending Light)12. ...
