Hyundai Tucson: Fuel Delivery System / Accelerator Pedal
1.Turn the ignition switch OFF and disconnect the battery (-) terminal.
2.Disconnect the accelerator position snesor connector (A).
3.Remove the upper mounting cap (B) and the loosen the mounting nut (C).
4.Remove the lower mounting cap (D) and the loosen the mounting bolt (E).
Tightening Torque :8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)
1.Install in the reverse order of removal.
Filler-Neck Assembly
- Removal
• Be careful not to damage the parts located under the vehicle
(floor under cover, canister, fuel tank) when raising the vehicle using
the lift.(Refer to General ...
Delivery Pipe
- Removal
Low Pressure Delivery Pipe
1.Release the residual pressure in fuel line.(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.Turn the ignition switch OFF and di ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Blind-Spot Collision-Avoidance
Assist Operation
Collision warning
When a vehicle is detected in a blind
spot, the warning light on the side view
mirror illuminates.
Blind-Spot Collision Avoidance Assist
operates when your vehicle speed
is above 12 mph (20 km/h) and the
speed of the vehicle in the blind spot
area is above 7 ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Integrated Thermal Management Module (ITM)
- Components
1. Integrated Thermal management Module (ITM)
1. Water inlet pipe2. O-ring
- Description
The Integrated Thermal management Module (ITM) is a device that
controls the coolant flow rate according to coolant temperature. At
initial startup, the ITM quickly warms up th ...
