
| No | Connector A | Connector B |
| 1 | Battery (+) | Front right door tweeter speaker (+) |
| 2 | Battery (+) | Front left door tweeter speaker (+) |
| 3 | Battery (+) | Sub woofer speaker (+) |
| 4 | Battery (+) | - |
| 5 | - | - |
| 6 | - | - |
| 7 | - | Navigation voice (+) |
| 8 | ACC | - |
| 9 | - | - |
| 10 | M- CAN (High) | - |
| 11 | M- CAN (Low) | - |
| 12 | - | Rear right door speaker (+) |
| 13 | - | Rear left door speaker (+) |
| 14 | - | Front center speaker (+) |
| 15 | - | - |
| 16 | Ground | Front right door tweeter speaker (-) |
| 17 | Ground | Front left door tweeter speaker (-) |
| 18 | Ground | Sub woofer speaker (-) |
| 19 | Ground | - |
| 20 | SPDIF (High) | - |
| 21 | SPDIF (Low) | Navigation voice (-) |
| 22 | SPDIF (GND) | - |
| 23 | - | - |
| 24 | IGN 1 | - |
| 25 | - | Rear right door speaker (-) |
| 26 | - | Rear left door speaker (-) |
| 27 | - | Front center speaker (-) |
| 28 | - |
1.Disconnect the negative (-) battery terminal.
2.Remove the front seat assembly [LH].(Refer to Body (Interior and Exterior) - "Front Seat Assembly")
3.Remove the external amplifier (A) after disconnecting connectors and loosening mounting bolts.

1.Install the external amplifier after connecting connectors.
2.Install the front seat assembly [LH].
3.Connect the negative (-) battery terminal.
– Make sure the connector are connected in properly.
– Check the AVN system for normal operation. (Navigation, Radio, USB, Bluetooth)
AVN Head Unit
SpeakersHyundai Tucson (NX4) 2022-2026 Service Manual: Tire
- Tire Wear
• Using tires and wheel other than the recommended sizes could
cause unusual handling characteristics and poor vehicle control,
resulting in a serious accident.
1.Measure the tread depth of the tires.Tread depth [limit] : 1.6 mm (0.0630 in.)
2.If the rema ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Description and Operation
- Description
Burglar Alarm State [B/A State]
B/A StateDescription
DISARM1)
In "DISARM" state, no vehicle start inhibition. So, when door, hood, or
Liftgate is opened, there is no alarm sound and flashing.
2) If the battery is disconnected while the state is not "ARM/ARMWAIT/ALARM/REARM" ...