Hyundai Tucson: Blower / Blower Motor
1.Connect the battery voltage and check the blower motor rotation.
2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.
3.Replace the blower motor if it is proved that there is a problem with it.
1.Disconnect the negative (-) battery terminal.
2.Press the lock pin (B) and then remove the crash pad under cover (A).
3.Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.
4.Install in the reverse order of removal.
Blower Unit
- Components Location
1. Blower unit assembly
- Components
1. Blower unit assembly2. Intake actuator3. Intake duct case [LH]4. Intake seal5. Intake door(1)6. Intake door(2)7. Intake du ...
Blower Resistor (Manual)
- Inspection
1.Measure the resistance between the terminals.
2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)
- Repla ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Smart Cruise Control Settings
Based on Drive Mode
Smart Cruise Control accelerates
differently based on the drive mode
selected from Drive Mode Integrated
Control system.
Information
For more information, refer to the
"Drive Mode Integrated Control
System" section in Chapter 6.
In some drive modes, Smart Cr ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Repair procedures
- Removal
1.Turn the steering wheel so that the front wheels can face straight ahead.
2.Turn the ignition switch OFF and disconnect the battery negative (-) cable.
3.Remove the drive airbag module.(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
4.Disconnect the steering ...
