Hyundai Tucson: Blower / Blower Resistor (Manual)
1.Measure the resistance between the terminals.
2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)
1.Disconnect the negative (-) battery terminal.
2.Remove the glove box.(Refer to Body (Interior and Exterior) - "Glove Box")
3.Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.
4.Install in the reverse order of removal.
Blower Motor
- Inspection
1.Connect the battery voltage and check the blower motor rotation.
2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operat ...
Power Mosfet (Dual)
- Inspection
1.Turn the ignition switch ON.
2.Manually operate the control switch and measure the voltage of the blower motor.
3.Select the control switch to raise the voltage until high speed. ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Emission Control System
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty
information contained in the Owner’s
Handbook & Warranty Information
booklet in your vehicle.
Your vehicle is equipped with an
emission control system to meet all
applic ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Liftgate Latch
- Component Location
1 . Liftgate latch assembly
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Disconnect the negative ...
