Hyundai Tucson: Rear Suspension System / Trailing Arm

- Removal

• When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister).(Refer to General Information - "Lift and Support Points")

1.Loosen the rear wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.

2.Remove the rear wheel and tire.(Refer to Suspension System - "Wheel")

3.Loosen the wheel speed sensor cable bracket mounting nuts (A).

Tightening torque :12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)

4.Separate the trailing arm after loosening the mounting nuts (A).

Tightening torque :98.0 - 117.6 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.7 lb-ft)

5.Remove the trailing arm (A) after loosening the mounting bolts.

Tightening torque :98.0 - 117.6 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.7 lb-ft)

1.Check the bushing for wear and deterioration.

2.Check for all bolts and nuts.

1.To install, reverse the removal procedures.

2.Check the alignment.(Refer to Suspension System - "Alingment")