Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
5. If desired, turn the air conditioning ON with the temperature control knob set to heat in order to dehumidify the air before it enters into the cabin.
If the windshield fogs up, set the mode
to the or
position.
Operation Tips
Air conditioning
1. Start the engine. Press the air conditioning button.
2. Set the mode to the position.
3. Set the air intake control to the outside air or recirculated air position.
4. Adjust the fan speed control and temperature control as desired.
NOTICE
Air conditioning system operation tips
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Rear Cross-Traffic Collision Warning (RCCW)
Rear Cross-Traffic Collision Warning uses
the rear corner radars to help detect
vehicles approaching from the left or
right while your vehicle is reversing, and
to warn you that a collision is imminent
with a warning message and an audible
warning.
A: Rear Cross-Traffic Collision Warn ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Rear Assist Arm
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
Points")
1.Loosen the rear wheel nuts slightly.Raise the v ...