Hyundai Tucson: Seat Belt Restraint System / Second row center seatbelt (3-point rear center seat belt)
Insert the tongue plate 1 into the buckle 2 until an audible “click" is heard, indicating the latch is locked. Pull the shoulder portion of the belt to snug the belt across your hips and remove slack. Make sure the seat belt is not twisted.
When using the rear center seat belt, use the buckle with the “CENTER” mark.
Information
If you cannot pull out the safety belt from the retractor, firmly pull the belt out and release it. After release, pull out the belt smoothly.
Passenger and Rear Seat Belts –
3-point system with convertible
locking retractor
This type of seat belt combines both
an emergency locking retractor and an
automatic locking retractor. Convertible
retractor type seat belts are installed
in the rear seat positions to help
...
Stowing the rear seat belt
The rear seat belt buckles can be stowed
in the pocket between the rear seatback
and cushion when not in use.
Routing the seat belt webbing through
the rear seat belt guides helps keep the ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Quarter Garnish
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Using a screwdriver or remover, remove the quarter garnish (A).
2.To install, r ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Repair procedures
- On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test
1.Check for DTCs.
• If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide)
2.Check if sparks occur. ■ Without diagnostic tool(1)Rem ...
