Hyundai Tucson: Air Conditioning System / Receiver-Drier
1.Remove the condensor.(Refer to Air conditioning System - "Condensor")
2.Using a Lwrench, remove the cap (A) on the bottom of the receiver-drier.
3.Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.
4. Install in the reverse order of removal.
• Always replace the receiver-drier and bottom cap at the same time.
• Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a or R-1234yf to avoid leakage.
• Be careful not to damage the radiator and condenser fins when installing the condenser.
• Charge the system, and test its performance.
Condenser
- Components Location
1. Condensor
- Inspection
1.Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent,
gent ...
A/C Pressure Transducer
- Description
The A/C Pressure Transducer (APT) converts the pressure value of high
pressure line into voltage value after measuring it. By converted
voltage value, engine ECU controls the cool ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Pillar Trim
- Component Location
1. Rear pillar trim
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take car ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Glass
- Removal
• In order to remove rear glass, use tools as follows shown in the picture.[Tooling Diagram]
â‘ Square wireâ‘¡ Insert type wire grip[Tools Assembly Diagram]
• Tighten square wire ①inserting it in the hole of Insert type wire grip ②
1.Remove the mov ...
