Hyundai Tucson: Floor Console / Rear Console Cover
1. Rear console cover
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the floor console assembly.(Refer to Floor Console - "Floor Console Assembly")
2.Loosen the mounting screws, disconnect the rear console cover connector (A).
3.Remove the rear console cover (A).
4.To install, reverse removal procedure.
• Make sure the connector is connected properly.
• Replace any damaged clips (or pin-type retainers).
Floor Console Assembly
- Replacement
[SBW type]
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves ...
Console Armrest
- Component Location
1. Console armrest
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damag ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Installing a Child Restraint
System
WARNING
Before installing your Child Restraint
System, always read and follow
the instructions provided by the
manufacturer of the Child Restraint
System and in this manual to prevent
serious injury or death if a collision
occurs.
WARNING
If the vehicle head restraint prevents
prope ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Lift and Support Points. General Information
General Information
- Lift and Support Points
[Two-Post Car Lift]
1.Place the lift blocks under the support points as shown in the illustration.
2.Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported.
3.Raise the hoist to full height to inspect t ...
