Hyundai Tucson: Seat Electrical / Lumber Support System
1.Disconnect the negative (-) battery terminal.
2.Remove the front seat back cover.(Refer to Body - "Front Seat Back Cover")
3.Disconnect motor connecotor (A).
4.Remove the front side airbag (A).
5.Remove the lumber support cable bracket after loosening mounting screws.
6.Remove the lumber support (A).
1.Install the lumber support assembly.
2.Install the seat back cover.
1.Remove the front seat back cover.
2.When the battery power is supplied to the motor connector, check the motor for smooth operation.
3.Reverse the connections and check that the motor turns in reverse.
4.If the motor runs abnormally, replace it.
Air Ventilation Seat
- Component Location
1. Air ventilation seat blower2. Air ventilation seat control unit3. Air ventilation seat duct
- Components
Pin Connector AConnector B
1IGN 1Ventilation heater bat ...
Fuses And Relays
...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Rear Brake Caliper
- Components
1. EPB Actuator2. Caliper body3. Caliper carrier4. Pad retainer5. Brake pad
- Removal
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(R ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Surround View Monitor (SVM) Unit
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the crash pad center panel.(Refer to Body - "Crash Pad Center Panel")
3.Disconnect the SVM unit connector (A).
4.Loosen the mounting nuts and remove the SVM Unit (A).
- Installation
1.Install the SVM unit.
2.Install ...
