Hyundai Tucson: Lighting System / Luggage Room Lamp
1.Disconnect the negative (-) battery terminal.
2.Using a flat-tip screwdriver and remove the luggage room lamp (A).
3.Disconnect the luggage room lamp connector (A).
1.Connect the luggage room lamp connector.
2.Install the luggage room lamp.
3.Connect the negative (-) battery terminal.
High Mounted Stop Lamp
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the rear spoiler.(Refer to Body - "Rear Spoiler")
3.Remove the high mounted stop lamp assembly (A) after loosening screws (4EA ...
Rear Combination Lamp
- Removal
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Joint Assembly (Wheel side)
- Removal
The type can replace the wheel side joint boot
1.Remove the front drive shaft.(Refer to Driveshaft Assembly - "Front Driveshaft")
2.Remove the trans axle side joint.(Refer to Driveshaft Assembly - "Transaxle Joint")
3.Remove the dynamic damper.(Refer to Driveshaft Assembly - "Dynam ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Surround View Monitor Settings
Camera settings
To change the settings of Surround View
Monitor's Display Contents or Display
Settings, press the setup icon ()
on
the screen while Rear View Monitor is
operating, or go to Setup > Vehicle >
Driver Assistance > Parking Safety >
Camera Settings from the Se ...
