
1 . Liftgate assembly
• Wear gloves to protect hands from injury.
• Be careful not to damage the liftgate and body.
• When removing and installing the liftgate, an assistant is needed.
1.Disconnect the negative (-) battery terminal.
2.Remove the liftgate lower trim.(Refer to Liftgate - "Liftgate Trim")
3.Disconnect the washer nozzle (A) and connector (B)..

4.Disconnect the connectors and liftgate wiring harness (A).

5.Using a screwdriver, lift the socket clips (A) up slightly on both ends of the liftgate lifter (B).

6.Loosen the liftgate hinge (A) mounting bolts, remove the liftgate assembly (B).
Tightening torque :21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

7.To install, reverse removal procedure.
• Make sure the liftgate locks / unlocks and opens / closes properly.
• Make sure the connectors are connected in properly.
• Adjust the liftgate alignment. (Refer to Liftgate - "Repair procedures")
Repair procedures
Liftgate TrimHyundai Tucson (NX4) 2022-2026 Service Manual: Rear Combination Lamp
- Removal
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the bumper cover and panels.
...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Engine oil pressure warning
light
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
Drive carefully to the nearest safe
location and stop your vehicle.
Turn the engine OFF and check the
engine oil level (For more information,
refer to the “Engine Oil” secti ...