Hyundai Tucson: Emergency Situations / In Case of an Emergency While Driving
If the Engine Stalls While Driving
- • Reduce the speed gradually, keeping
a straight line. Move cautiously off the
road to a safe place.
- • Turn on your hazard warning flasher.
- • Try to start the engine again. If your
vehicle does not start, contact an
authorized HYUNDAI dealer or seek
other qualified assistance.
If the Engine Stalls at a Crossroad
or Crossing
If the engine stalls at a crossroad or
intersection, if safe to do so, shift the
gear to N (Neutral) and then push the
vehicle to a safe location.
If You Have a Flat Tire While
Driving
If a tire goes flat while you are driving:
- • Take your foot off the accelerator
pedal and let the vehicle slow down
while driving straight ahead. Do not
apply the brakes immediately or
attempt to pull off the road because
this may cause loss of vehicle control
resulting in a collision. When the
vehicle has slowed to such a speed
that it is safe to do so, brake carefully
and pull off the road. Drive off the
road as far as possible and park on
a firm, level ground. If you are on a
divided highway, do not park in the
median area between the two traffic
lanes.
- • When the vehicle is stopped, press the
hazard warning flasher button, shift
the gear to P (Park), apply the parking
brake, and move the ignition switch to
the LOCK/OFF position.
- • Have all passengers get out of the
vehicle. Make sure they all get out on
the side of the vehicle that is away
from traffic.
- • When replacing a flat tire, follow the
instructions provided later in this
chapter.
The hazard warning flashers warn other
drivers to exercise extreme caution when
approaching, overtaking, or passing your
vehicle.
It should be used whenever making
emergency repairs or when ...
• Be sure to shift the gear to N (Neutral)
or P (Park). The engine starts only
when the gear is in N (Neutral) or P
(Park).
• Turn on the interior light. If the light
dims or goes ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: SBW Control Unit(SCU)
- Component Location
1. Shift by wire Control Unit (SCU)
- Schematic Diagrams
PinFunctionPinFunction
1Power21-
2Ground22-
3H-CAN High23-
4H-CAN Low24-
5P-CAN High25-
6P-CAN Low26-
7Position sensor ground27Position sensor signal 1
8-28Position sensor signal 2
9-29P position o ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Key Ignition Switch
WARNING
To reduce the risk of serious injury or
death:
Never allow children or any person
who is unfamiliar with the vehicle to
touch the ignition switch or related
parts. Unexpected and sudden vehicle
movement may occur.
Never reach through the steering
wheel for the ignitio ...