Hyundai Tucson: Hood / Hood Latch
1. Hood Latch Assembly
• Put on gloves to prevent hand injuries
1.Disconnect the negative (-) battery terminal.
2.Remove the front bumper assembly.(Refer to Front Bumper - "Front Bumper Assembly")
3.Disconnect the hood latch cable (A).
4.Press the rock pin to separate the hood latch connector (A) and disconnect wiring clip.
5.Loosen the mounting bolts, remove the hood latch assembly (A).
6.To install, reverse removal procedure.
• Make sure the hood latch release cable is connected properly.
• Make sure the hood locks / unlocks and opens / closes properly.
• Adjust the latch alignment.(Refer yo Hood - Repair procedures")
Hood Latch Release Handle
- Component Location
1. Hood latch release handle
- Replacement
1.Using a socket, remove the hood release handle (A).
2.To install, reverse removal procedure.
• M ...
Liftgate
...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Description and Operation
- Description
The system detects the passenger in the vehicle and prevents the driver
from getting off the vehicle with the passenger in the back.
– 1st warning: If you open the driver's door after you open and then
close the rear passenger and turn the engine off, the system provides
...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Roof Side Molding
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Using a screwdriver or remover, remove the roof side molding (A).
2.To install, ...
