Hyundai Tucson: Crash Pad / Glove Box
1. Glove box
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Open the glove box (A).
2.Remove the air damper (A) from the glove box.
3.Press the side of the glove box and remove the glove box (A).
4.Install in the reverse order of removal.
• Replace any damaged clips (or pin - type retainers).
Crash Pad Lower Panel
- Component Location
1. Crash pad lower panel
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent ...
Steering Column Shroud Panel
- Component Location
1. Steering column shorud lower panel3. Steering column shorud upper panel [General cluster]2. Steering column shorud upper panel [Supervision cluster]
- Replacement
...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Jump Starting
Jump starting can be dangerous if done
incorrectly. Follow the jump starting
procedure in this section to avoid serious
injury or damage to your vehicle. If in
doubt about how to properly jump start
your vehicle, have a service technician or
towing service do it for you.
WARNING
To pre ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Joint Assembly (Wheel side)
- Removal
The type can replace the wheel side joint boot
1.Remove the front drive shaft.(Refer to Driveshaft Assembly - "Front Driveshaft")
2.Remove the trans axle side joint.(Refer to Driveshaft Assembly - "Transaxle Joint")
3.Remove the dynamic damper.(Refer to Driveshaft Assembly - "Dynam ...
