Hyundai Tucson (NX4) 2022-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Steering Column Shroud Panel

Hyundai Tucson: Crash Pad / Steering Column Shroud Panel

- Component Location

1. Steering column shorud lower panel
3. Steering column shorud upper panel [General cluster]
2. Steering column shorud upper panel [Supervision cluster]

- Replacement [Steering column shroud upper panel]

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• Put on gloves to prevent hand injuries.

• Take care not to bend or scratch the trim and panels.

1.Remove the crash pad garnish[LH].(Refer to Crash Pad - "Crash Pad Garnish")

2.Loosen the mounting screw, remove the steering column shroud upper panel (A).[Supervision cluster]

[General cluster]

3.To install, reverse removal procedure.

• Replace any damaged clips (or pin-type retainers).

[Steering column shroud lower panel]

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• Put on gloves to prevent hand injuries.

• Take care not to bend or scratch the trim and panels.

1.Remove the steering column shroud upper panel.

2.Remove the crash pad lower panel.(Refer to Crash Pad - "Crash Pad Lower Panel")

3.Loosen the mounting screws by turning the steering wheel to the left and right, and remove the steering column shroud lower panel (A).

4.To install, reverse removal procedure.

• Replace any damaged clips (or pin-type retainers).

Glove Box

- Component Location 1. Glove box - Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to co ...

Crash Pad Air Vent

- Component Location 1. Crash pad air vent [LH]2. Crash pad air vent [RH] - Replacement [LH] • When removing with a flat-tip screwdriver or remover, wrap protectiv ...

Other information:

Hyundai Tucson (NX4) 2022-2026 Service Manual: Components and Components Location
- Components Location 1. Supplemental Restraint System Control Module (SRSCM)2. Gravity Side Impact Sensor (G-SIS) _ C pillar3. Gravity Side Impact Sensor (G-SIS) _ B pillar4. Front Impact Sensor (FIS) [RH]5. Front Impact Sensor (FIS) [LH]6. Pressure Side Impact Sensor (P-SIS) ...

Hyundai Tucson (NX4) 2022-2026 Service Manual: Air Cleaner
- Removal and installation Air Cleaner Assembly 1.Disconnect the battery negative terminal. 2.Remove the engine cover.(Refer to Engine And Transaxle Assembly - “Engine Cover”) 3.Remove the air duct (A). 4.Remove the air cleaner assembly.(1)Disconnect the air flow sensor connector (A) ...