Hyundai Tucson: Fuel Delivery System / Fuel Pressure Regulator
1.Remove the fuel pump.(Refer to Fuel Delivery System - "Fuel Pump")
2.Disconnect the fuel sender connector (A).
3.Release the fixing hook (A) and then remove fuel sender (B) in the arrow direction.
4.Disconnect the fuel pump motor connector (A).
5.Remove the fixing pin (A) and then disconnect the fuel feed tube (B).
6.Release the fixing hook (A) and then remove the head assembly (B).
7.Release the fixing hook (A) and then remove the reservoir-cup (B).
8.Disconnect the fuel pump motor connector (A).
9.Disconnect the ground cable (B).
10.Remove the fixing pin (A) and then disconnect the fuel pressure regulator (B).
1.Install in the reverse order of removal.
Fuel Sender
- Removal
1.Remove the fuel pump.(Refer to Fuel Delivery System - "Fuel Pump")
2.Disconnect the fuel sender connector (A).
3.Release the fixing hook (A) and then remove fuel sender (B) in the ...
Fuel Line
- Removal
Low Pressure Fuel Line [Low Pressure Delivery Pipe ↔ Fuel Tank]
• Be careful not to damage the parts located under the vehicle
(floor under cover, canister, fue ...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Repair procedures
- Removal
1.Turn the steering wheel so that the front wheels can face straight ahead.
2.Turn the ignition switch OFF and disconnect the battery negative (-) cable.
3.Remove the drive airbag module.(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
4.Disconnect the steering ...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Knock Sensor (KS)
- Description
Knocking is a phenomenon characterized by undesirable vibration and
noise and can cause engine damage. Knock Sensor (KS) is installed on the
cylinder block and senses engine knocking.When knocking occurs, the
vibration from the cylinder block is applied as pressure to the
pi ...
