Hyundai Tucson: Body Side Molding / Front Wheel Guard
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.Remove the front tire.(Refer to Suspension System - "Wheel")
3.Loosen the mounting nuts, bolts and screws, remove the front wheel guard (A).
4.To install, reverse the removal procedure.
• Replace any damaged clips (or pin-type retainers).
C Pillar Garnish
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Rear Wheel Guard
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Vehicle Auto-Shut Off
If your vehicle is parked and the engine
is left on for a long period of time, the
engine turns off automatically to help
reduce fuel consumption and prevent
carbon dioxide poisoning.
Operating Conditions
Vehicle Auto-Shut Off timer operates
when all the following conditions are
satisf ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Overhead Console Lamp
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the overhead console cover (A).
3.Remove the mounting screws.and then remove the overhead console (A).
4.Remove the overhead console after disconnect the connector (A).
- Installation
1.Install the overhead console l ...
