Hyundai Tucson: Body Side Molding / Rear Wheel Guard
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Remove the rear tire.(Refer to Suspension System - "Wheel")
2.Loosen the mounting nuts and screws, remove the rear wheel guard (A).
3.To install, reverse the removal procedure.
• Replace any damaged clips (or pin-type retainers).
Front Wheel Guard
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Roof Side Molding
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Blind-Spot Collision-Avoidance
Assist Operation
Collision warning
When a vehicle is detected in a blind
spot, the warning light on the side view
mirror illuminates.
Blind-Spot Collision Avoidance Assist
operates when your vehicle speed
is above 12 mph (20 km/h) and the
speed of the vehicle in the blind spot
area is above 7 ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Cowl Top Cover
Components and Components Location
- Component Location
1. Cowl Top Cover
Repair procedures
- Replacement
1.Remove the cap and the nuts, and then remove the wiper arm (A).Tightening torque :22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)
2.Disconnect the washer nozzle (A).
...
