Hyundai Tucson: Body Side Molding / C Pillar Garnish
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Using a screwdriver or remover, remove the C pillar garnish (A).
2.To install, reverse the removal procedure.
• Replace any damaged clips (or pin-type retainers).
Door Garnish
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Front Wheel Guard
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent h ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Windshield Wipers
Operates as follows when the ignition
switch is turned ON.
MIST: For a single wiping cycle,
move the lever up (MIST) and
release it. The wipers operate
continuously if the lever is
held in this position.
OFF: Wipers are not in operation.
INT: Wipers operate intermittently
at the same ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: IMS (Integrated Memory System) module
- Components
IMS input/output pin information
PinConnector AConnector BConnector C
1-B+ (Power)Seat slide motor switch (Forward)
2Seat recline motor (Forward)Ground (Power)Seat recline switch (Forward)
3Seat height motor (Up)B+ (Power)Seat tilt switch (Up)
4Seat slide motor(Forward)-Seat ...
