Hyundai Tucson: Warning and Indicator Lights / Forward Safety warning light. Lane Safety indicator light
Forward Safety warning light
This warning light illuminates:
- When the ignition switch is in the ON position. The Forward Safety warning light illuminates for about 3 seconds and then goes off.
- Whenever a malfunction with Forward Collision-Avoidance Assist is detected.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
For more information, refer to the “Forward Collision-Avoidance Assist (FCA)” section in Chapter 7.
Lane Safety indicator light
This indicator light illuminates:
- Green: When Lane Keeping Assist operating conditions are met.
- White: When Lane Keeping Assist operating conditions are not met.
- Yellow: Whenever a malfunction with Lane Keeping Assist is detected. If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
For more information, refer to the “Lane Keeping Assist (LKA)” section in Chapter 7.
Low tire pressure warning
light
This warning light illuminates:
When the ignition switch is in the
ON position. The Low Tire Pressure
warning light illuminates for about 3
seconds and then goes off.
When one or more ...
4 Wheel Drive (AWD) warning
light. 4 Wheel Drive (AWD) LOCK
indicator light
4 Wheel Drive (AWD) warning
light
This warning light illuminates:
Whenever a malfunction with the AWD
system is detected.
If this occurs, have the vehicle inspected
by an authorized HYUNDAI ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Troubleshooting
- Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition Of Electronic Parts' Resistance
The measured resistance at high temperature after vehicle running may be
high or low. So all resistance must be measured a ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Relay Box (Engine Compartment)
- Inspection
Power Relay (Type A)
1.There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
2.There should be no continuity between the No.30 and No.87 terminals when power is disconnected.[Engine room relay box]
...
