Hyundai Tucson: Automatic Transaxle Control System / Electronic Shift Actuator
| Item | Specification | |
| Motor | Voltage(V) | 10 - 16 |
| Electric current (A) | 36.41 @ 16V, - 40ËšC (- 104ËšF) | |
| Coil resistance (Ω) | 1.15 - 1.40 @ 20˚C (60˚F) | |
| Sensor | Voltage(V) | 4.7 - 5.3 |
| Electric current (mA) | 10 - 20 | |
[Circuit Diagram]
1.Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.Remove the air duct and the air cleaner assembly.(Refer to Engine Mechanical System - "Air cleaner")
3.Disconnect the electronic shift actuator connector (A) and then separate the wiring clip (B).
4.Loosen the bolts and then removing the electronic shift actuator (A).
Tightening torque :20.6 - 26.5 N.m (2.1 - 2.7 kgf.m, 15.2 - 19.5 lb-ft)
1.To install, reverse the removal procedure.
SBW Control Unit(SCU)
- Component Location
1. Shift by wire Control Unit (SCU)
- Schematic Diagrams
PinFunctionPinFunction
1Power21-
2Ground22-
3H-CAN High23-
4H-CAN Low24-
5P-CAN High25-
6P-CAN Low26 ...
Transaxle Oil Temperature Sensor
- Description
• Transaxle oil temperature sensor monitors the automatic transaxle fluid's temperature and conveys the readings to TCM.
• It is an NTC (Negative Thermal Coefficient) sensor w ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Emergency Liftgate Safety
Release
To unlock and open the liftgate manually
from inside the cargo area, perform the
following:
1. Insert a long, flat object, such as a key
into the opening at the bottom of the
liftgate.
2. Slide the latch in the direction of the
arrow to unlock the liftgate.
3. Push the liftgate open.
...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Compression Pressure Inspection
• If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.Start the engine until coolant temperature goes up to 80-95°C and stop the engine.
2.Remove the spark coils.(Refer to E ...
